Metabo HPT CC 14SF Manual De Instrucciones página 5

12. Always make a trial run fi rst, before attempting any new use of the tool.
13. Always use only the peripheral surface of the cut-off wheel.
14. Always handle the cut-off wheel with care, when dismounting and mounting it.
15. Always keep your hands out of the line of the cut-off wheel.
16. Always confi rm that the safety cover are in the proper places, before using the tool.
17. Inspect the tool power cord periodically.
18. Always confi rm that the proper lengths and types of extension cords are being utilized, when
if needed, before starting the tool.
19. Always confi rm that the motor air vents are fully open, before using the tool.
20. Always wait until the motor has reached full speed, before starting a cut.
21. Always keep the handles dry, clean and free of oil and grease. Hold the tool fi rmly, when in
use.
22. Always fi x the motor section using the chain when carrying about the tool.
23. Always keep the cut-off wheels in a dry place, as humidity aff ects the strength of the cut-off
wheels.
DON'Ts
NEVER VIOLATE THE FOLLOWING RULES, TO ASSURE SAFE USE THIS TOOL:
1. Never operate the POWER TOOL unless you fully understand the operating instructions
contained in this Manual.
2. Never leave the POWER TOOL, unattended, without fi rst unplugging the power cord.
3. Never operate the POWER TOOL when you are tired, or after you have taken any medications
or have consumed any alcoholic beverages.
4. Never use the POWER TOOL for applications not specifi ed in the Instruction Manual.
5. Never operate the tool while wearing loose clothing, a necktie or jewelry, or while your hair is
uncovered, to protect against getting caught in the moving machinery.
6. Never reach around or behind the cut-off wheel.
7. Never touch any moving parts, including the cut-off wheel, while the tool is in use.
8. Never remove any safety devices or wheel guards; use of the tool without them would be
hazardous.
9. Never lock the safety cover, (always confi rm that it slides smoothly, before using the tool).
10. Never abuse the power cord of the tool.
11. Never attempt to move a plugged-in POWER TOOL while your fi nger is on the starting
switch.
12. Never use the POWER TOOL if the starting switch doesn't turn on and off properly.
13. Never use the POWER TOOL if the plastic housing or the handle is cracked or deformed.
14. Never use the POWER TOOL near fl ammable liquids or gases, since sparking could cause
an explosion.
15. Never clean plastic components with solvents, since the plastic may dissolve.
16. Never operate the tool unless all of the wheel guards are in place.
17. Never allow the cut-off wheel to be struck against a hard object, as it might get cracked.
18. Never twist the cut-off wheel during cutting operation.
19. Never expose hands, feet and fragile things to the grinding sparks, as the grinding sparks
may harm them.
20. Never use the lateral side of the cut-off wheel.
English
5