SKF TKSA 40 Instrucciones De Uso página 19

• To modify the dimensions given in the section 3.4 (B, C or motor speed), navigate to
the Adding /Modifying dimension icon and press OK.
See below for the procedure to enter or modify a dimension.
• Result screen without a given motor rotational speed
If the motor rotational speed is not given, the status of the alignment can not be
compared by the unit with the maximum acceptable misalignment value.
• Result screen, with the B and C dimension and / or motor speed not given.
If the B and C dimensions are not given in section 3.4, the feet adjustment values can
not be calculated by the unit.
See below for the procedure to enter or modify a dimension.
{
Coupling
values
Angular
Parallel/ offset
Rotational
speed of the
motor
Fig. 18 Results screen display without B, C dimension given
Enter or modify a dimension
To get an indication of the alignment status compared with the maximum acceptable
misalignment value, the motor rotational speed must be given.
Navigate to the adding/modifying dimension icon and press OK. With the selection arrows,
navigate to the required rotational speed field.
Enter the rotational speed with the help of the alphanumeric keyboard, or press OK to
display the recommended maximum acceptable misalignment table (see section 3.4).
The display is automatically updated with the status of the alignment compared with the
maximum acceptable misalignment value.
18
Vertical
Distance between the
MU marked "M" and
the front feet of the
moveable machine
Horizontal
Distance between
the front and rear
feet of the moveable
machine
Main
result screen
Measurement
module
Soft foot mode
Save results
File manager
SKF TKSA 40