•
Always turn off the power of the drive machine before you start
working.
•
Do not expose the equipment to rough handling or heavy impacts.
•
Always read and follow the operating instructions.
•
The tool uses two laser diodes with an output power below 1 mW.
Still, never stare directly into the laser transmitter.
•
Calibrate the equipment regularly.
•
Never aim the laser line into someone's eyes.
•
Opening the housing of the measuring unit may result in hazardous light
exposure and voids warranty.
•
The equipment should not be used in areas where there is a risk for
explosion.
•
Do not expose the equipment to high humidity or direct contact with
water.
•
All repair work should be taken care of by an SKF repair shop.
4
Safety recommendations
SKF TKSA 40