Temperature Selector - TATRA TPI 05 D.V Manual De Instrucciones

L1 Thermostat light
L2 Humidification Light
L5 Cooking programs led
L6 Cooking cycle led
L10 START / STOP cooking light
L11 CELSIUS led
L12 FAHRENHEIT led
B1

Temperature selector


ON/OFF
When power is supplied to the oven the control panel lights up and the operating display
indicates temperature in cooking chamber.The oven now is ready for operating.

START/STOP COOKING PROGRAM
This button starts/stops a previously set program or cooking cycle.

TEMPERATURE SELECTOR
When the oven is on "ON" the temperature display shows the temperature in the
cooking chamber.To set the desired cooking temperature press the temperature
selector and press (+) or (-) buttons for INCREASE or DECREASE. The
temperaturedisplay will show the set value. Press the temperature button for
confirmation or wait 5 seconds and it will automatically be confirmed. Values go from
30°C to 260°C.During cooking the CHAMBER display shows actual internal chamber
temperature and to see the set temperature you must press "temperature button".
Heating element led is on red when the heat is on and green when it is off.

TIMER
Press Timer button, to set the time value by acting on (+) or (-) for INCREASE or
DECREASE. The time which appears on the display must be confirmed pressing the
timer button or wait 5 seconds for automatic confirmation.
The programmable times range is 999 minutes.
Acting on the timer button if you go under value of "1" on display you will see "----":
means "infinite time" the oven will continue to work with the set parameters until
START/STOP button is pressed. The time display will start count-up so you can see
from how long the oven is operating.
In case you set minutes on the time display will start countdown during cooking.
•
STEAM
Enables humidifying in manual cooking or to program the various humidity settings
during process.
- Humidifying in manual cooking: during cooking, the STEAM button enables the release
of steam into the cooking chamber for as long as it is pressed. The STEAM led will be
on. If the motor turns the other way (only for models with inverter system), humidifying
will stop briefly.
- To program automatic humidifying during cooking: after pressing the STEAM button, it
is possible to increase or decrease the humidity by pressing + / -. It ranges from: OFF –
20% - 40% - 60% - 80% - 100%. During programming the values flash on the display
and pressing STEAM again will memorize them or wait 5 seconds for automatic
confirmation.
E n g l i s h | 16
B2 Steam selector
B3 ON /OFF button
B4 Timer selection
B5 Cooking programs
B10 START / STOP cooking
B11 Speed regulation
B12 Increase button
B13 Decrease button