Power Failure - TATRA TPI 05 D.V Manual De Instrucciones

PROGRAMMED COOKING
The oven has 99 pre-programmed recipes, each one with 3 cooking phases (1,2,3,).
To create a new cooking program, with the oven in ON/STANDBY, press the RECIPE button
and on display will appear "P01", acting on + / - button you go to the program number desired
+ press the RECIPE button for confirmation.
Now the oven will be in position of first cooking cycle (N. 1 led will be on) and you can select
the time, temperature and steam in the various phases as below:
- Select the temperature button and with +/- introduce the value desired + press the
temperature button for confirmation.
- Select the time button and with +/- introduce the value desired + press the the time button
for confirmation.
- Select the Steam button and with +/- introduce the value desired + press the the Steam
button for confirmation.
- Select the cooking cycle button (C) to go at second phase (in case the cooking process as
different phases) and you will see the Cooking cycle led on under N. 2. Now you can settle
the time, temperature, steam as previously describe and go to "cooking cycle" N. 3. If you
have 3 phases you can save the program with the RECIPE button (press until the led
flashes). In case you have only 1 or 2 phases on the new phase leave "0" under time and
save the program.
- When program is saved you can press START/STOP to activate the cooking process.
- The oven will start to pre-heat and after "beep" will be ready to load the food. After
introduced the food will start the program settled, the PHASES led always shows the
current program phase.
- END flashes on the display at the end of a cooking cycle, fan, humidifying and heating stop
and it beeps for 40 seconds.
It is permitted to modify program data is loaded before baking and cooking in execution, to
adapt cooking product needs.
For manual cooking cycle, all changes made before or during cooking are impermanent, i.e.
are not persisted: If you bring the unit into Standby and then back in ON the manual cycle is
reset to default values.
Changes that were made during the cooking stage are valid only for cooking.
If you press C in a program cooking you can go to the next phases before the end of the time.
To delete the program, change the time of the first phase in infinity time and save the
program.
RETURN TO MANUAL COOKING
To go back to MANUAL you have to follow the procedure below to exit programs:
Press ON-OFF until MANU (manual) will appear on the display.
TIME ON DISPLAY
When the oven started the cooking program the time display will show the countdown.
In case you use "INF" time the oven will show the count-up of cooking time.

POWER FAILURE

In case of power failure during the cooking cycle, the oven turns in OFF position.
E n g l i s h | 18