TATRA TPI 05 D.V Manual De Instrucciones página 137

- During cooking, the STEAM led goes on when steam is being released into the cooking
chamber and it stop briefly when the motor turns the other way (only models with
inverter system).
- Pressing the HUMIDIFICATION button whilst cooking generates vapour in the cooking
chamber for the entire time it is pressed.
The set of humidification is allowed only before running a cycle.
• COOKING CYCLE
The oven is suitable for 3 different cooking phases for each cooking program
(1,2,3).
• COOKING CYCLE LED
The led that is on will show you in which cooking phase is operating (1,2,3).
•
HEATING ELEMENTS LED
When heating elements are working the led is on.

CELSIUS / FAHRENHEIT LED
The led for Celsius or Fahrenheit will be on to indicate in which condition the oven is
operating.
• COOKING PROGRAMS
To program a cooking process press the button and acting on + / - you can select the
program number to set. After selected the program number confirm pressing on cooking
program button. Each program can be modified any time.

AUTOMATIC PREHEATING
This function is automatic for all cooking programs (manual or programmable).
This pre-heats the oven to 20% value higher than the set temperature. This function is
necessary to compensate for the loss of heat through opening the door to put food in.
When a program starts the oven first starts this preheat cycle ("PRE" on the display and
the first cooking cycle led "P" will light), it beeps at the end and only stops when the door
is opened. The previously selected program starts automatically when the door is
closed.
The beeping can be stopped by pressing any button other than opening the door.
During pre-heating is not possible to use the humidity.
MANUAL COOKING
Press ON/OFF button to active the oven and after setting TEMPERATURE, TIME, STEAM
(see previous instruction) the cooking cycle begins by pressing START/STOP. The oven will
start to pre-heat and after "beep" will be ready to load the food. After introduced the food will
start the program settled.
START/STOP. During the cooking process you can modify the Temperature and the Time,
only the automatic STEAM figure cannot be changed during operating, you need to stop the
oven and modify manually.
Manual STEAM can be introduced any time pressing the STEAM button.
During the cooking process the time display will show the count-down.
END flashes on the display at the end of a cooking cycle, fan, humidifying and heating stop
and it beeps for 40 seconds.
E n g l i s h
The cooking cycle may be stopped at any time by pressing
| 17