Temperature Selector - TATRA TPI 05 D.V Manual De Instrucciones

L10 START / STOP cooking light
L11 CELSIUS led
L12 FAHRENHEIT led
B1

Temperature selector


ON/OFF
When power is supplied to the oven the control panel lights up and the operating display
indicates temperature in cooking chamber.The oven now is ready for operating.

START/STOP COOKING PROGRAM
This button starts/stops a previously set program or cooking cycle.

TEMPERATURE SELECTOR
When the oven is on "ON" the temperature display shows the temperature in the cooking
chamber.To set the desired cooking temperature press the temperature selector and
press (+) or (-) buttons for INCREASE or DECREASE. The temperaturedisplay will show
the set value. Press the temperature button for confirmation or wait 5 seconds and it will
automatically be confirmed. Values go from 30°C to 260°C.During cooking the CHAMBER
display shows actual internal chamber temperature and to see the set temperature you
must press "temperature button". Heating element led is on red when the heat is on and
green when it is off.

TIMER
Press Timer button, to set the time value by acting on (+) or (-) for INCREASE or
DECREASE. The time which appears on the display must be confirmed pressing the timer
button or wait 5 seconds for automatic confirmation.
The programmable times range is 999 minutes.
Acting on the timer button if you go under value of "1" on display you will see "----": means
"infinite time" the oven will continue to work with the set parameters until START/STOP
button is pressed. The time display will start count-up so you can see from how long the
oven is operating.
In case you set minutes on the time display will start countdown during cooking.
•
STEAM
Enables humidifying in manual cooking or to program the various humidity settings during
process.
- Humidifying in manual cooking: during cooking, the STEAM button enables the release
of steam into the cooking chamber for as long as it is pressed. The STEAM led will be on.
If the motor turns the other way (only for models with inverter system), humidifying will
stop briefly.
- To program automatic humidifying during cooking: after pressing the STEAM button, it is
possible to increase or decrease the humidity by pressing + / -. It ranges from: OFF –
20% - 40% - 60% - 80% - 100%. During programming the values flash on the display and
pressing STEAM again will memorize them or wait 5 seconds for automatic confirmation.
- During cooking, the STEAM led goes on when steam is being released into the cooking
chamber and it stop briefly when the motor turns the other way (only models with inverter
system).
- Pressing the HUMIDIFICATION button whilst cooking generates vapour in the cooking
chamber for the entire time it is pressed.
The set of humidification is allowed only before running a cycle.
E n g l i s h | 16
B10 START / STOP cooking
B11 Speed regulation
B12 Increase button
B13 Decrease button