TATRA TPI 05 D.V Manual De Instrucciones página 180

•
COOKING CYCLE
The oven is suitable for 3 different cooking phases for each cooking program
(1,2,3).
•
COOKING CYCLE LED
The led that is on will show you in which cooking phase is operating (1,2,3).
•
HEATING ELEMENTS LED
When heating elements are working the led is on.

CELSIUS / FAHRENHEIT LED
The led for Celsius or Fahrenheit will be on to indicate in which condition the oven is
operating.
•
COOKING PROGRAMS
To program a cooking process press the button and acting on + / - you can select the
program number to set. After selected the program number confirm pressing on cooking
program button. Each program can be modified any time.

AUTOMATIC PREHEATING
This function is automatic for all cooking programs (manual or programmable).
This pre-heats the oven to 20% value higher than the set temperature. This function is
necessary to compensate for the loss of heat through opening the door to put food in.
When a program starts the oven first starts this preheat cycle ("PRE" on the display and
the first cooking cycle led "P" will light), it beeps at the end and only stops when the door
is opened. The previously selected program starts automatically when the door is closed.
The beeping can be stopped by pressing any button other than opening the door. During
pre-heating is not possible to use the humidity.
MANUAL COOKING
Press ON/OFF button to active the oven and after setting TEMPERATURE, TIME, STEAM (see
previous instruction) the cooking cycle begins by pressing START/STOP. The oven will start to
pre-heat and after "beep" will be ready to load the food. After introduced the food will start the
program settled. The cooking cycle may be stopped at any time by pressing START/STOP.
During the cooking process you can modify the Temperature and the Time, only the automatic
STEAM figure cannot be changed during operating, you need to stop the oven and modify
manually.
Manual STEAM can be introduced any time pressing the STEAM button.
During the cooking process the time display will show the count-down.
END flashes on the display at the end of a cooking cycle, fan, humidifying and heating stop and
it beeps for 40 seconds.
PROGRAMMED COOKING
The oven has 99 pre-programmed recipes, each one with 3 cooking phases (1,2,3,).
To create a new cooking program, with the oven in ON/STANDBY, press the RECIPE button
and on display will appear "P01", acting on + / - button you go to the program number desired
+ press the RECIPE button for confirmation.
Now the oven will be in position of first cooking cycle (N. 1 led will be on) and you can select
the time, temperature and steam in the various phases as below:
- Select the temperature button and with +/- introduce the value desired + press the
temperature button for confirmation.
E n g l i s h | 17