Use With A Gravity Balancer - Prebena KTVH-B19D Manual De Instrucciones Original

Prepare stapler

Use with a gravity balancer

You can use the air-powered stapler units with a gravity balancer. To
attach the rope of the gravity balancer at the stapler unit, you must
attach a suspension eyelet on the casing head. Proceed as follows:
 Remove the compressed air hose from the unit (see page 33).
 Empty the magazine (see page 33).
 Loosen and remove the two rear cylinder screws (15) on the
housing head.
Position the suspension eyelet (17) as shown below.

 Fasten the suspension eyelet (17) with the cylinder screws (15).
The suspension eyelet is now ready for use.
 Check the condition of the driving tool (see page 16)
The suspension eyelet (item number: Z85608001) is available as an
accessory from PREBENA (see page 44)
20