Operate stapler
Check driving depths
Replace the stapler with the mouth of a cardboard material.
Press the trigger button or the hand lever. A fastener is driven
through the box and formed by both benders.
Check the setting by a simple triggering on the sample material
(see page 31).
Repeat these steps until you have set the desired driving depth
and staple bending.
Drive in the fasteners
30
WARNING
During operation, eye damage or other injury
may occur from flying splinters.
Wear safety goggles during operation and
suitable protective clothing.
Comply with the applicable health and
safety regulations.
WARNING
Hearing damage is possible due to loud noise
operation.
Wear suitable hearing protection.
Comply with the applicable noise
regulations.
Select the lowest possible operating
pressure.