Faults; Remove Jammed Fasteners - Prebena KTVH-B19D Manual De Instrucciones Original

Faults

Faults
ATTENTION
The stapler unit can be damaged by unauthorized people during
repairs.
 Make sure that repairs to the stapler unit are only performed
by the manufacturer.

Remove jammed fasteners

To remove a jammed fastener, proceed as follows:
 Disconnect the stapler unit from the compressed air supply (see
page 33).
 Empty the magazine (see page 33).
 Pull back the pusher and snap it on.
 Loosen the jam in the device with a thin pair of pliers or a
screwdriver
 Move the pusher again carefully into position.
 Remove the jammed or deformed fasteners.
 Connect the compressed air supply (see page 17).
 Fill the magazine as described on page 20.
 Check the functioning of the stapler unit (see page 24).
If you cannot eliminate the fault, contact your dealer or the
manufacturer (see page 48).
40
WARNING
When operating a damaged or faulty stapler
unit serious or fatal injuries may occur.
 Disconnect the stapler unit immediately
from the compressed air supply in case of
fault (see page 33).
 Empty the magazine (see page 33).
 Use the stapler unit only when the problem
is resolved.