Check Function - Prebena KTVH-B19D Manual De Instrucciones Original

Operate stapler

Check function

To ensure proper operation of the stapler unit, proceed as follows:
ATTENTION
 Observe the safety instructions in the chapter "Safety" on page
8.
 Place the mouth opening on a sample cardboard material with the
thickness of the material to be processed.
 Trigger the stapler device (see chapter "Drive in fasteners" on
page 31).
 To do this, check the following properties:
-
At each triggering a fastener must be driven in the cardboard
material.
 In order to obtain the desired bending image, change the staple
setting (6/7) (see page 31), the depth setting (3) (see page 25) or
the setting of staple length (9) (see page 26)
 W If necessary, repeat these steps.
The stapler unit is now ready for use.
24