Denon AVR-3802 Instrucciones De Operación página 11

2
Switch to the speaker configuration screen.
ENTER
SHIFT
3
Set whether or not speakers
TUNING
are connected and, if so, their
size parameters.
BAND MODE
• To select the speaker
TUNING
TUNING
• To select the parameter
BAND MODE
TUNING
4
Press the ENTER button to finalize the settong.
ENTER
SHIFT
NOTE:
• Select "Large" or "Small" not according to the actual size of the speaker but according to the speaker's
capacity for playing low frequency (bass sound below frequency set for the Crossover Frequency mode and
below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level
low enough so as not to damage the speakers) to determine the proper setting.
• Parameters
Large.................Select this when using speakers that have sufficient performance for reproducing bass
sound below the frequency set for the Crossover Frequency mode.
Small .................Select this when using speakers that do not have sufficient performance for reproducing
bass sound below the frequency set for the Crossover Frequency mode. When this is set,
bass sound with a frequency below the frequency set for the Crossover Frequency mode
is sent to the subwoofer.
When this setting is selected, low frequencies of below the frequency set for the Crossover
Frequency mode are assigned to the subwoofer.
None...... ..........Select this when no speakers are installed.
Yes/No... ...........Select "Yes" when a subwoofer is installed, "No" when a subwoofer is not installed.
2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
"Small" is set for the front, center and surround speakers.
For the majority of speaker system configurations, using the Small setting for all five main speakers and
Subwoofer On with a connected subwoofer will yield the best results.
All manuals and user guides at all-guides.com
Selecting the surround speakers for the different surround modes
This screen is displayed when using both surround speakers A and B.
• At this screen preset the surround speakers to be used in the different surround modes.
1
Center Sp.
Front Sp.
Subwoofer
Surround Sp. A
2
Surround back Sp.
Surround Sp. B
Speaker type setting when using both surround speakers A and B
If "Small" is set for either surround speakers A or B, the output is the same as when "Small" is set for both
A and B.
Setting the Crossover Frequency and Subwoofer mode
This screen is displayed when using a subwoofer.
• Set the crossover frequency and subwoofer mode according to the speaker system being used.
1
2
3
When either "Large" or "Small" has been set for both
TUNING
speakers A and B on the System Setup Menu (when using
both A and B surround speakers), the surround speaker
BAND MODE
setting screen appears.
TUNING
Select the surround speakers to be used in the different
surround modes.
• To select the surround mode
• To select the surround speaker
TUNING A: When using surround speakers A
B: When using surround speakers B
BAND MODE
A+B: When using both surround speakers A and B
TUNING
Enter the setting.
ENTER
When "Front" is set to "Large" and "Subwoofer" is set to "Yes", the set switches to the
SHIFT
subwoofer mode.
Select the "Crossover Frequency" mode.
TUNING
BAND MODE
TUNING
Select the Frequency.
TUNING
BAND MODE
TUNING
Select the "Subwoofer Mode".
TUNING
BAND MODE
TUNING
Select the setting.
TUNING
BAND MODE
TUNING
Enter the setting.
ENTER
The System Setup Menu reappears.
SHIFT
ENGLISH
11