Leister LQS Instrucciones De Funcionamiento página 25

Setting the Parameters for Welding Data Recording
Setting the maximum temperature alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the minimum force alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the maximum force alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the speed tolerance alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the distance interval:
• See Setting the threshold value for recording for the setting procedure.
Switching off GPS (optionally, as required):
• See Switching on data recording for the setting procedure.
• In the function display (33), rotate the "e-Drive"
.
Running Welding Data Recording
to select the symbol "Return to working display"
• Set the parameters for welding data recording (see Chapters
"Preparing for Welding Data Recording" and "Setting the Pa-
rameters for Welding Data Recording").
• Set the setpoints for temperature and speed
(see Chapter "Speed and Temperature Setting Before Welding"
in the device operating instructions).
• Switch on the heating and drive.
In the status line (35), the file number is displayed alternately
in the network voltage display and the
• Activate clamping arm.
Recording begins as soon as the force exceeds the set threshold
value.
In the status line (35), the file number is displayed alternately
in the network voltage display and the
• If a set alarm value is exceeded during the welding process, this is
shown in the display when alarm value monitoring is switched on.
(See Chapter "Displaying Alarm Value Transgressions in the
Welding Data Record During the Welding Process")
In such cases, make changes depending on the situation
(see Chapter "Speed and Temperature Setting During Welding"
in the device operating instructions).
symbol flashes.
symbol is shown.
25