Leister LQS Instrucciones De Funcionamiento página 28

Data Synchronization
The welding data files recorded by the automatic welder are read by the "LQS app" and synchronized. For this to
take place, the WLAN module of the automatic welder must be switched on.
Important: Data must regularly be synchronized with the "LQS app". Otherwise, unsynchronized welding data can
be lost from the device; for example, if the operating unit is defective.
Switching on the WLAN module:
• In the function display (33), rotate the "e-Drive"
• Press "e-Drive"
• Select "WLAN Settings" in the "Setup" menu by rotating the "e-Drive"
• Rotate the "e-Drive"
Rotate the "e-Drive"
• In the function display (33), rotate the "e-Drive"
Switching off the WLAN module:
• In the function display (33), rotate the "e-Drive"
• Press "e-Drive"
• Select "WLAN Settings" in the "Setup" menu by rotating the "e-Drive"
• Rotate the "e-Drive"
Rotate the "e-Drive"
• In the function display (33), rotate the "e-Drive"
28
briefly.
to select "WLAN" and press "e-Drive"
to select "I" and press "e-Drive"
WLAN connection status display:
The data exchange between the automatic welder and the LQS app starts from the LQS app.
symbolis displayed in the status line (35) when the automatic welder is connected to
The
the "LQS app".
briefly.
to select "WLAN" and press "e-Drive"
to select "0" and press "e-Drive"
to select the Settings menu
and pressing it briefly.
briefly.
briefly.
to select the symbol "Return to working display"
to select the Settings menu
and pressing it briefly.
briefly.
briefly.
to select the symbol "Return to working display"
.
.
.
.