To Lubricate The Blade Shaft Bearings; Troubleshooting; Troubleshooting Schedule - Husqvarna Soff-Cut 150 Manual Del Usuario

The air cleaner assembly is a cyclone type, it is on the
engine at the front of the saw. Replace the air cleaner
element, refer to the maintenance schedule. If
necessary, replace more frequently.
For more information, refer to the operator's manual for
the engine.
To do a check of the drive belt
• Make sure that the drive belt does not have
damages or visual defects.
• The belt tensioner controls the belt tension. It is not
necessary to adjust the belt tension.
• Make sure that the belt tensioner moves freely up
and down.
• Make sure that the belt tensioner bearings move
freely.
To replace the guide wheels (Soff-
Cut 150D)
Use the ¼ʺ wide guide wheels when chasing ¼ʺ saw
cuts with the XL6- V25-D blade. Front and rear guide
wheels are included with the saw.
Note: Both front and rear guide wheels must be
replaced; do not mix different width guide wheels.
1. Remove lock nut and slide out the shoulder bolt.

Troubleshooting schedule

WARNING: Troubleshooting causes risk of
injury because personnel does work in the
22
2. Make a note of the washers and other parts removed
and the order of assembly.
3. Slide the bronze bushing from inside the old front
guide wheel and insert into the new one.
4. Slide the bronze bushing from inside the old rear
guide wheel and insert into the new one.
5. Install the new guide wheels using the same
shoulder bolts, lock nuts and plastic washers.
Half-inch wide guide wheels, not included with the saw,
are also available for use with ProEdge Blade XL6-
V500-D, when chasing ½ʺ wide saw cuts.

To lubricate the blade shaft bearings

• Lubricate the blade shaft bearings with 3 pumps of
grease.
For the correct type of grease, refer to
data on page 28 .
Maintenance of the engine
Refer to the operator's manual for the engine for
additional information about servicing of the engine. The
operator's manual for the engine also has information
about specifications, tune-up parts, engine warranty,
emission compliance, etc.

Troubleshooting

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
risk areas of the product. Be careful, prepare
the work and use common sense.
714 - 004 - 06.07.2021
Technical