Tabla de contenido
Publicidad
ENGLISH
BATTERY OPERATED HYDRAULIC CRIMPING TOOL
B131-UC
The "B131-UC" hydraulic tool is powered by 14.4 V battery. A balanced tool for optimum
control; quiet in operation with very little vibration; lightweight construction enables the
operator to hold the tool in one hand and to position the connector with the other hand.
The operating buttons (operating/release) are mechanically interlocked; the former is
integrated into the latter, so that accidental operating is prevented. A microprocessor
controls the tool operation and automatically cuts out the motor, on completion of the
crimping operation, saving energy and extending battery life.
The residual battery capacity level is automatically displayed after every cycle.
The part reference "B131-UC" includes the following:
– Basic tool complete with battery and shoulder strap.
– Spare battery.
– Battery charger.
– Carrying case "VAL P19".
1. GENERAL CHARACTERISTICS
– Application range: is suitable both for compression of electrical connectors on
conductors up to 400 mm
2
up to 300 mm
(600 MCM).
– Crimping force: .................................................................... 130 kN
– Rated operating pressure: .................................................. 700 bar
– Dimensions: length ............................................................. 435 mm
width .............................................................. 100 mm
height ............................................................. 250 mm
– Weight: (with battery) ............................................................ 7,1 kg
– Motor - direct current: ............................................................ 14.4 V
– Battery: ................................................................................. 14.4 V – 3.0 Ah – Li-Ion
– External supply: ................................................................... 12 V ÷ 14.4 V DC
– Operating temperature: ....................................................... -15°C to +40°C
– Recommended oil: .................................... AGIP ARNICA 32
– Operating speed: the tool has a twin speed operation and automatically switches, from
a rapid advancing speed of the ram to a slower, more powerful crimping speed.
– Safety: the tool is provided with a maximum pressure valve.
2
(800 MCM) and aluminium conductors
(14.6 sh ton)
(10,000 psi)
(17.1 in.)
(3.9 in.)
(9.8 in.)
(15.6 lbs)
(+5°F to +104°F)
or
SHELL TELLUS TX 32
or equivalent
3
FIG. 9
LONGITUDINAL SECTION - COUPE LONGITUDINALE
SCHNITTZEICHNUNG - SECCION LONGITUDINAL - SEZIONE LONGITUDINALE
44
Publicidad
Tabla de contenido
