Troubleshooting - Snapper ESPV211S Manual Del Operador

Troubleshooting

PROBLEM
Engine Will Not Start 1. Fuel tank empty.
2. Spark plug wire disconnected.
Engine Stalls or Loses 1. Blade control is released or is not being held
Power After Running securely against handle.
2. Fuel tank empty.
3. Engine air pre-cleaner and or air cleaner dirty. 3. Clean free of all debris.
4. Spark plug defective or gap set improperly.
5. Water, debris or stale fuel in fuel system.
Excessive Vibration 1. Damaged, out of balance or bent mower
blade.
2. Loose blade components.
3. Loose or missing air lift (if equipped).
4. Lumpy or frayed belt.
Mower Will Not Move / 1. Build-up of debris on or around wheel drive
Loss Of Traction components.
2. Transmission cable adjustment required.
3. Drive belt requires replacement.
4. Damaged transmission.
Cutting Grass 1. Cutting height too low or high.
Improperly
2. Forward ground speed too fast.
3. Terraced cut, side to side.
4. Excessive deck pitch, front to rear.
5. Cutting blade dull or damaged.
Poor Grass Discharge 1. Forward speed too fast.
2. Grass is wet.
3. Excessively worn or damaged blade.
4. Build up of grass clippings and debris under
deck.
5. Improper blade installed on deck.
6. Blade installed improperly on deck.
Oil Leaking 1. Loose dipstick.
2. Loose drain plug.
3. Oil level is overfilled.
4. Damaged oil seals.
16
All manuals and user guides at all-guides.com
PROBABLE CAUSE CORRECTIVE ACTION
1. Fill fuel tank with fresh fuel.
2. Place spark plug wire onto spark plug.
1. Blade control should be held securely against
handle at all times during operation of mower.
2. Fill with fuel to proper level.
4. Service spark plug.
5. Drain and clean fuel system.
1. Contact authorized dealer.
2. Contact authorized dealer.
3. Contact authorized dealer.
4. Contact authorized dealer.
1. Clean debris.
2. Contact authorized dealer.
3. Contact authorized dealer.
4. Contact authorized dealer.
1. Adjust cutting height.
2. Move ground speed control to a slower speed.
3. Adjust height of cut with height adjust levers.
4. Adjust height of cut with height adjust levers.
5. Contact authorized dealer.
1. Move ground speed control to a slower speed.
2. Mow when grass is dry.
3. Contact authorized dealer.
4. Clean deck.
5. Contact authorized dealer.
6. Contact authorized dealer.
3. Make sure dipstick/oil filler cap is securely in
place.
2. Check and tighten drain plug.
3. drain excess oil.
4. Contact authorized dealer.
www.snapper.com