System Operation; Powering The System On And Off - Stryker X8000 Light Source Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
4.
To remove the light cable, press the Mode button to put the unit into Standby
mode. Then turn the jaw handle clockwise until it latches fully open.
W
I
ARNING
REMOVING THE CABLE
DIRECTLY OUT OF THE LIGHT SOURCE BRIEFLY BEFORE TURNING
OFF
Note
The Light Source will default to Standby mode when a light cable
is inserted.

System Operation

Note
Before operating the X8000, see the "Setup and Assembly" section
of this manual.

Powering the System On and Off

Caution
Do not power the system on and off in rapid succession. Allow
the bulb to run for at least five minutes once it has been
powered on, before turning the power off. Failure to do so can
cause the bulb to rapidly darken and fail.
To power on the X8000:
1.
Confirm that the X8000 contains a properly installed bulb. The bulb
handle must be turned all the way to the left, to ensure proper latching. If
no bulb is installed, follow the instructions in the "Replacing the Bulb"
section of this manual before proceeding.
2.
Press the power switch on the front panel. The Standby LED will
illuminate, indicating the unit is in Standby mode.
Note
The bulb will not illuminate unless a light cable is installed in the
cable port.
To power off the X8000:
1.
Put the light source unit into Standby mode.
2.
Disconnect the light cable from the X8000 console.
3.
Run the fan for at least one minute to cool the unit.
4.
Press the power switch on the front panel of the X8000.
W
T
ARNING
SIDE FAN VENTS
RESULT IN DAMAGE TO THE
10
F THE LIGHT SOURCE IS NOT IN
,
POSSIBLY CAUSING INJURY TO THE USER
O ALLOW FOR ADEQUATE COOLING
. F
S
TANDBY MODE PRIOR TO
,
THE HIGH INTENSITY LIGHT WILL SHINE
AILURE TO FOLLOW THIS INSTRUCTION MAY
X8000
'
.
S EYES
,
NEVER BLOCK THE REAR OR
OR A POSSIBLE FIRE
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

220-200-000

Tabla de contenido