Angelcare AC-SP El Manual Del Propietario página 4

All manuals and user guides at all-guides.com
of fire or electric shock. NEVER spill liquid of any
kind on the product.
11.15 Power Lines - An outside antenna system
should NOT be located in the vicinity of overhead
power lines or other electric light or power circuit,
or where it can fall into such power lines or circuits
as contact with them may be fatal.
11.16 Vibration Source - When the monitor is
in use, DO NOT use a cot mobile or other cot
accessories that may produce vibrations. Other
sources of vibrations may include fans, washing
machines, loud music, etc. These sources of
vibration may interfere with the performance of
your Angelcare ® monitor and the alarm will not
sound if it continues to detect any movement
other than your baby's. Be sure all vibration
sources are eliminated before using the monitor.
You may experience false alarms for several reasons.
The most common reason is the Camera has not
been turned OFF after you have removed your baby
from the cot. Another reason is the Sensor Pad
has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with
the Angelcare logo side facing up. The sensitivity
®
level may also need to be adjusted. Refer to Step
3.3. Always be sure to immediately check on baby
whenever an alarm sounds.
11.17 Sensor Pad - Your Sensor Pad can be used
in any cot that is stationary. If the cot has a
spring or slat base, place a hard board between
the cot base and the Sensor Pad measuring at
least 33 x 33 cm and 6 mm thick. Only use your
Angelcare monitor in a stationary sleeping
®
environment such as a cot where the Sensor
Pad can rest on a completely flat, firm surface.
The Sensor Pad is made of plastic and does not
permit the air to circulate. Therefore, mildew build
up could develop underneath the mattress in the
Sensor Pad area. We suggest rotating the mattress
regularly to prevent any mildew.
4