Angelcare AC-SP El Manual Del Propietario página 7

1.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your cot does not have a solid, stable surface for the Sensor Pad, you will
need to place a support under it, to ensure correct operation of the system.
This hardboard support should be at least 6 mm thick and should have
minimum dimensions of 33 cm x 33 cm. This support board must be larger
than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except
memory-foam mattresses, hollow frame mattresses and water beds. The
hardboard maintains a constant pressure on the Sensor Pad, enabling it to
detect the baby's movements even when the baby is at the edges of the cot.
2
Sensor Pad
4
6
7
CLICK!
4
All manuals and user guides at all-guides.com
3
5
4
6
3
5
8 cm
3 2
1) Remove the mattress
from the cot.
2) Place the Sensor Pad –
Angelcare logo side up –
on top of the hardboard.
2
3) Run the connection pin,
1
warning label and the
first 5 cord covers down
along the backside of
the cot leg, between the
mattress support and the
inside edge of the cot.
4) Bring the first 4 cord
covers down the floor,
and keep the 5th cord
cover vertically, along
the backside of the
cot leg, between the
mattress and the inside
edge of the cot.
5) Remove any cord slack
to make sure no parts
of the cord are loose.
6) Place the 6th cord
cover approximately
8 cm from the edge of
the mattress support.
7) Snap together the
remaining cord covers that
will run along the floor.
1
E
N
Hardboard
7