Peltor Lite-Com Pro Guia De Inicio Rapido página 5

430–470 MHz
The user is responsible for obtaining any necessary licences for using the
communication radio in the Lite-Com Pro!
II 1 G
The user is responsible for ensuring that the Lite-Com Pro is used according to the
applicable regulations in explosive environments!
INSTRUCTIONS FOR USE/SETTINGS
ON/OFF/MODE
Switch the Lite-Com Pro on and off by pressing and holding the ON/OFF/MODE button for about 
seconds. A tone confirms that the unit has been switched on or off. A slowly blinking LED on the button
shows that the Lite-Com Pro is on. When the unit is transmitting or receiving, the LED blinks faster.
Press / / (¡) briefly to move through the menu. Press the button slowly, one step at a time,
on off mode
to confirm each step in a voice message. If you press the button faster, you will only receive voice
confirmation of the function where you stop.
Current settings are stored when the unit is switched off.
SURROUND (ambient noise level)
Ambient sound amplification – when the Lite-Com Pro is used as an active hearing protector – is
regulated with the (+) and
up
can also switch off ambient noise by reducing the volume to its lowest position using the
then holding the button for about 2 seconds. A voice message says "S
ambient noise has been switched off.
WARNING! This setting attenuates ambient noises through the hearing protector, and they may become
inaudible. To re-activate the function, press
volume hearing protector that limits volume.
VOLUME
Use the (+) and (–) buttons to set the incoming volume in the communication radio. A voice
up down
message confirms the new setting each time you press the button. There are max. 7 volume steps and
an off mode. To access off mode, press and hold the
volume. A voice message confirms "
Note: No radio communication is audible in off mode.
To switch the radio back on, press the
CHANNEL
Up to 30 channels can be used in the 430–470 MHz frequency range. (Contact an approved Peltor
dealer to program your unit.)
Use the (+) and (–) buttons to select a channel (radio frequency) for the communication radio. A
up down
voice message confirms the new setting each time you press the button.
VOX (Voice-operated transmission)
VOX means that the Lite-Com transmits when sounds of a certain volume reach the microphone
– hands-free transmission.
The Lite-Com Pro also has busy channel lockout (BCLO), which means that voice-operated transmission
is not possible if the channel is already in use. This prevents interference.
Use the (+) and (–) buttons to set the sensitivity for voice-operated transmission. A voice
up down
message confirms the new setting each time you press the button. There are five VOX levels and an
off mode. To access off mode, press and hold the
confirms " ". If you want to transmit, you must use the PTT button. To switch VOX on again,
volume off
press the (+) button.
up
All manuals and user guides at all-guides.com
EEx ia IIC T4
(–) selectors. The change is confirmed with a voice message. You
down
(+) and the Lite-Com Pro once again works as an active-
up
down
".
volume off
(+) button. You start receiving on the lowest volume level.
up
down
urround off
(–) button for two seconds when at the lowest
(–) button for two seconds. A voice message
(–) button,
down
", confirming that the