Kobalt SGY-AIR88TZ Manual De Instrucciones página 5

SA FETY INFORMATION
Use a face mask/respriator and protective clothing when spraying. Always spray in a
well ventilated area to prevent health and fire hazards. Refer to material saftey data
sheets (MSDS) of spray materials for details.
Certain materials that can be used with this device if coming in direct contact with skin
may cause skin irritation.
Read the label or materials safety data sheet for the materials you intend to use to find
out which materials may cause skin irritation.
Always disconnect tool from air supply before performing any maintenance.
Never use a tool which is leaking air, has missing or damaged parts, or requires repair.
Only use parts and accessories recommended by the manufacturer.
Improper operation or maintenance of air tool could result in serious injury and
property damage. Read and understand all warnings and operation instructions
before using spray guns. When using spray guns, basic safety precautions should
always be followed to reduce the risk of personal injury.
SOME DUST CREATED BY PAINT SPRAYING, POWER SANDING, SAWING,
GRINDING, DRILLING, AND OTHER RELATED ACTIVITIES IS KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND OTHER
REPRODUCTIVE HARM. A LISTING OF CHEMICALS CAN BE OBTAINED FROM
www.oehha.ca.gov UNDER PROPOSITION 65. SOME EXAMPLES OF THESE
CHEMICALS ARE:
LEAD FROM LEAD BASED PAINTS
CRYSTALLINE SILICA FROM BRICKS, CEMENT AND OTHER MASONRY
PRODUCTS
ARSENIC AND CHROMIUM FROM CHEMICALLY TREATED LUMBER
YOUR RISK FROM THESE EXPOSURES VARIES, DEPENDING ON HOW OFTEN
YOU DO THIS TYPE OF WORK. TO REDUCE YOUR EXPOSURE TO THESE
CHEMICALS WORK IN A WELL VENTILATED AREA, AND WORK WITH
SPECIALLY DESIGNED TO FILTER MICROSOPIC PARTICLES. APPROVED
SAFTEY EQUIPMENT, SUCH AS A RESPIRATOR OR DUST MASKS WHICH ARE
SPECIALLY DESIGNED TO FILTER MICROSOPIC PARTICLES.
Do not remove Brass baffle attached to front of gun body as special technical traning
and tools are required. Only authorized service centers should remove this part.
To avoid cross-threading, all spray gun parts should be initially screwed in by hand and
hand tightened only. If the parts cannot be easily turned by hand, be sure you have the
correct parts, unscrew, realign and secure properly in matching parts.
All manuals and user guides at all-guides.com
WA R N I N G
WA R N I N G
CAUTION
5