Kobalt SGY-AIR88TZ Manual De Instrucciones página 9

REPAIR INSTRUCTION
Remove air pressure from air hose / gun.
CAUTION: Take care not to damage the seals on the gun body when removing the
air distribution ring.
1. Remove the nozzle set:
a. Remove air cap w/ring by turning counter clockwise (See Figure 1).
b. Unscrew the fluid adjustment knob by turning counter clockwise (See Figure 2).
c. Pull out needle spring and paint needle (See Figure 3).
d. Remove paint nozzle using wrench provided (See Figure 4).
1 1
Counter clockwise
4
2. Pull out the air distribution ring using needle-nose pliers
(not included) and remove dirt (See Figure 5).
NOTE: Make sure that dirt has not settled in the sealing surfaces and no scratches
prevent optimum sealing performance. Use care and caution not to damage the air
distribution ring. Reconnect air hose with spray gun set to desired PSI.
3.The clean air distribution ring must be inserted in a way that the plastic pin marked
with an arrow (1) fits smoothly into the hole marked (2) (See Figure 6). Firmly push
in the air distribution ring in place (See Figure 7). Insert the paint nozzle and tighten
slightly. Make sure the air distribution ring fits securely against the gun body.
All manuals and user guides at all-guides.com
2
Counter clockwise
5
9
3