Changing Hydraulic Oil And Filters - Rapid UNIVERSO 1500 Manual De Instrucciones

7.4

Changing hydraulic oil and filters

When refilling oil or checking the oil level, the machine must be positioned horizontally.
Machine no. from CH 1001
Hydraulic oil
Oil level check
1
• Bring the machine into a horizontal posi-
tion.
• Unscrew the charging screw (A) with
integrated oil level gauge.
• Check the oil level on the level gauge. If
necessary, refill prescribed oil until the oil
level is within the two marks.
• Screw in the charging screw (A) with
integrated oil level gauge.
Oil change
• Dismount the base plate (B).
• Unscrew the drain plug (C).
• Drain off the oil.
• Unscrew banjo bolt (D), unscrew old oil
filter (E).
• Apply oil to the sealing ring on the new oil
filter.
• Screw in new oil filter, tighten banjo bolt
(D).
• Screw in the drain plug (C).
• Mount the base plate.
• Bring the machine into a horizontal
position.
• Unscrew the charging screw (A) with
integrated oil level gauge.
• Refill oil until the oil level reaches the
maximum mark of the level gauge.
• Screw in the charging screw (A) with
integrated oil level gauge.
• For better ventilation of the hydraulic
system, the connecting piece of the
machine must be lifted by pressing the
handlebar downward.
• Slowly drive the machine forwards and
backwards.
• Switch off the engine.
• Check the oil level (see above).
Attention
EN
161