Storage; Assistance And Repairs; Warranty Coverage; Maintenance Table - Stiga ST 4851 AE Uso Y Mantenimiento

Never wash the snow thrower with
water, otherwise the electric device will be
damaged causing the risk of electrocution.

9. STORAGE

If you intend to put your machine
away for more than 30 days:
5. Clean the snow thrower thoroughly.
6. Check for any damage. If necessary,
see to the necessary repairs.
7. If the paintwork is damaged,
touch it up to prevent rust.
8. Protect any exposed metal surfaces from rust.

10. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorized Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorized
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorized service workshops can carry
out guaranteed repairs and maintenance.
• The authorized service workshops
only use genuine spare parts. Genuine

12. MAINTENANCE TABLE

Safety checks/check controls
Always check the electric devices are intact and working properly
Check the auger rotates freely
Apply silicone spray on the auger, to avoid ice formation
Check all the screw connections are tight. Tighten, if necessary.
Check the starter lever is only activated on
release of the disengaged starter lever
General cleaning and inspection
Intervention
spare parts and accessories have been
designed specifically for machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to expire.
• It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance
and safety device inspection.

11. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as drive belts, drills, headlights,
wheels, bolts and wires.
• Normal wear and tear.
• Motors. Motors are covered by the
warranty provided by the relative
manufacturer in compliance with the
specified terms and conditions.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged
by the national laws in his own country are
not in any way restricted by this warranty.
Before and after each use
At the end of each operation
EN - 11
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
Paragraph
6.2
6.2
6.2.1
6.3
4
5.3
8.2