Warning Symbols; Machine Symbols - Garland MONTANA FIRST Manual De Instrucciones

English

3. WARNING SYMBOLS

The warning labels which figure below accompany
the important information about the product or the
instructions for use.
The warning labels which figure below
accompany the important information about
the product or the instructions for use.
You must read this manual carefully before
using this machine.
Use eye and ear protection at all times.
Use this tool with both hands.
Danger of kickback.
Warning and caution.

4. MACHINE SYMBOLS

To ensure safe operating and maintenance, the
symbols are embossed on the tool.
Fuel tank. Located on the tank cap.
MIX 2.5% (PETROL 40: OIL 1).
Chain oil tank. Located on the tank cap.
Positions of the ignition switch. Located on the left
side of the machine.
"O" = ignition off (the tool will not
"I" = ignition on (the tool can operate).)
PULL
PUSH
"H" = High revolution adjustment screw.
"L"= Low revolution adjustment screw.
"T" = Idle adjust nut.
Chain brake position:
White Arrow = Brake not activated
(Normal operating position)
Black Arrow = Brake activated
Direction of installing the cutting chain
Indicator.
¡Never use only petrol or petrol in a bad
condition!. Use new lead free 95º petrol
and 100% synthetic oil for two stroke
engines. Engine fuel: mix (petrol 40:
oil 1) 2,5%.
40/172
operate)
Choke lever positions::
Pull the Choke to close the air
passage. Push the Choke to open
the airway. Located on the right
side of the machine.
Chain oil flow adjustment.