Setting The Mortise Width; Setting The Mortise Depth - Festool DOMINO XL DF 700 EQ Manual De Instrucciones

a) with selection slide
Loosen the clamp lever for the routing height
adjustment [4-1].
Using the front handle [4-2] raise the front part
of the guide frame.
Use the selection switch to set [4-4] the desired
routing height
25 mm; 30 mm; 40 mm).
Press the front section of the guide frame down-
wards as far as the stop.
Close the clamp lever [4-1].
b) freely selectable
Loosen the clamp lever for the routing height
adjustment [4-1].
Using the front handle [4-2] raise the front sec-
tion of the guide frame.
Pull the selection slide [4-4] as far as the stop
in the direction of the motor unit.
Set the desired routing height using the scale
[4-3] by moving the front section of the guide
frame vertically.
Close the clamp lever [4-1].
The alignment of the clamp lever [4-1] can be
aligned by raising the levers. When tightened,
the levers should not protrude beyond the con-
tact surface.

Setting the Mortise Width

CAUTION
Damage to the tool; bend or break the mortising
bit
Never force the lever to turn.
Never rotate the lever during a plunging opera-
tion.
12
All manuals and user guides at all-guides.com
(10 mm; 15 mm; 20 mm;
5
5-1
13,5 mm
Use the adjusting lever [5-2] to adjust the width of
the dowel hole you intend to cut for an adequate fit
or set with 3 mm play:
Tight fitting dowel 13.5 mm + cutter diameter
Dowel with lateral 16.5 mm + cutter diameter
play
You can see on the display [5-1] what dowel hole
width is selected.

Setting the Mortise Depth

The mortising depth determines how deep into the
workpiece the mortising bit penetrates. This needs
to be adjusted for different sized tenons.
In most cases, the tenon should be centered across
the joint, and the depth of the mortise should be ½
the length of the tenon. However, in some cases you
may want to have more of the tenon in one piece
than the other. In this case, the sum of the two
depths must equal the length of the tenon.
WARNING
Cutter can come out at the rear side of the work-
piece.
Risk of injury
Set the routing depth at least 5 mm less than the
workpiece thickness.
Press one or two snap buttons [6-1].
Set the slide for the routing depth setting [6-2]
to the desired routing depth (15 - 70 mm).
Release the snap buttons [6-1].
With the two markers [6-3], you can mark two
routing depths and switch easily between them
16,5 mm
5-2