Setting The Mortise Width - Festool DOMINO XL DF 700 EQ Manual De Instrucciones

is the distance between the bottom of the fence face
and the centerline of the mortising bit.
There are two features available for setting the
fence height:
4
4-2
4-3
4-4
h
15 mm
4-1
h
a) with selection slide

Loosen the clamp lever for the routing height
adjustment [4-1].

Using the front handle [4-2] raise the front part
of the guide frame.

Use the selection switch to set [4-4] the desired
routing height h (10 mm; 15 mm; 20 mm;
25 mm; 30 mm; 40 mm).

Press the front section of the guide frame down-
wards as far as the stop.

Close the clamp lever [4-1].
b) freely selectable

Loosen the clamp lever for the routing height
adjustment [4-1].

Using the front handle [4-2] raise the front sec-
tion of the guide frame.

Pull the selection slide [4-4] as far as the stop
in the direction of the motor unit.

Set the desired routing height h using the scale
[4-3] by moving the front section of the guide
frame vertically.

Close the clamp lever [4-1].
 The alignment of the clamp lever [4-1] can be
aligned by raising the levers. When tightened,
the levers should not protrude beyond the con-
tact surface.

Setting the Mortise Width

CAUTION
Damage to the tool; bend or break the mortising
bit

Never force the lever to turn.

Never rotate the lever during a plunging opera-
tion.
11