Water Supply And Drain Connections - Hoshizaki FM-2000ALE-N Manual De Instrucciones

ENGLISH
to the terminal which is marked with the letter L or
coloured Red.
* Should the socket outlets in the installation site not
be suitable for the plug supplied with your product,
the plug must be removed (cut off if it is moulded on
plug) and an appropriate plug fitted.
If the non-rewirable plug has been cut from the power
supply cord, it must be disposed of. There should
be no attempt to reuse it. Inserting such a plug into
a socket elsewhere presents a serious risk of
electrical shock.
* The non-rewirable plug must never be used without a
fuse cover being fitted.
The correct replacement for the detachable fuse
cover is identifiable from the manufacturer's reference
number stamped on the plug.
Supply of replacement fuse covers can be obtained
from Hoshizaki Parts/Service Centres.
Fuses should be rated at 13A and approved to BS
1362.
3. WATER SUPPLY AND DRAIN
CONNECTIONS
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
* Only potable water should be used for the icemaker.
* Water supply pressure should be minimum 0.5 bar
and maximum 8 bar. If the pressure exceeds 8 bar,
use a proper pressure reducing valve. Do NOT throttle
back the supply tap.
* The icemaker drain is gravity flow, so ensure drain
pipe has an adequate pitch or fall.
* Water should drain into an open trap.
All manuals and user guides at all-guides.com
II. OPERATING INSTRUCTIONS
1. This icemaker is designed to produce edible
2. The use of any electrical equipment involves
3. All parts are factory-adjusted. Improper
4. If the unit is turned off, wait for at least 3
1. OPERATION
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is plugged into the power supply.
Note: The flake size is adjustable to standard and large
2
WARNING
ice. To keep the icemaker hygienic:
* Wash your hands before removing ice. Use
the Plastic Scoop provided (accessory).
* The Storage Bin is for ice use only. Do not
store anything else in the Bin.
* Clean the Storage Bin before use (see "III.
1. CLEANING").
* Keep the Scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the Door after removing ice to prevent
entrance of dirt, dust or insects into the
Storage Bin.
the observance of some fundamental rules.
In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
* Do not pull the power cord in order to
disconnect the icemaker from the feed
network.
* This appliance is not suitable for
unsupervised use by young children or aged
or infirm persons.
adjustments may result in failure.
minutes before restarting the icemaker to
prevent damage to the Compressor.
sizes. The adjustment is made by removing
one of the two identical cutters combined
together. The unit is shipped from the factory
in the standard size. If adjustment is desired,
please contact an authorized Hoshizaki service
company.
91U2CM21B0303