Preparing The Icemaker For Long Storage - Hoshizaki FM-2000ALE-N Manual De Instrucciones

2. PREPARING THE ICEMAKER FOR
LONG STORAGE
1) Push the Stop Button on the Operation Panel. The
Display will blink in the "STOP" mode for 15 minutes
during the drain control operation and will start to
illumintate constantly at the end of drain control.
2) Close the water supply tap.
3) Remove the Inlet Hose from the water tap, and drain
the Hose.
4) Unplug the icemaker.
5) Remove all ice from the Storage Bin, and clean the
Bin.
III. MAINTENANCE
1. CLEANING
1. Before carrying out any cleaning or
maintenance operations, unplug the icemaker
from the electrical supply network.
2. This appliance must not be cleaned by use of
a water jet.
[1] Machine and Bin Exterior
Wipe the exterior at least once per week with a clean,
soft cloth. Use a damp cloth containing a neutral
cleaner to wipe off grease or dirt.
[2] Scoop and Storage Bin Handle Cleaning/
Sanitisation (Daily)
1) Either mix 3 litres of water with 11 ml of 5.25%
sodium hypochlorite solution in a suitable container,
or the recommended Hoshizaki sanitiser as directed.
2) Soak the Scoop in the solution for more than 3
minutes. Rinse thoroughly, and shake to remove
surplus liquid.
Note: Using a cloth to dry may re-contaminate.
3) Use a neutral cleaner to wash the Storage Bin
Handle. Rinse thoroughly.
91U2CM21B0303
All manuals and user guides at all-guides.com
WARNING
4) Soak a clean cloth with the sanitising solution, and
wipe the Handle. Use fresh water and a clean cloth
to rinse/dry.
[3] Storage Bin Interior Cleaning/Sanitisation
(Weekly)
1) Open the Storage Bin Door, and remove all ice.
2) Remove the Thumbscrews securing the plastic Ice
Deflector.
3) Remove the Ice Deflector from the Bin.
4) Wash the Bin liner, Ice Deflector and Door inner
surface with a neutral non-abrasive cleaner. Rinse
thoroughly.
5) Either mix 5 litres of water with 18 ml of 5.25%
sodium hypochlorite solution in a suitable container,
or the recommended Hoshizaki sanitiser as directed.
6) Soak a clean sponge or cloth with the solution, and
wipe the Bin liner, Ice Deflector and Door inner
surface.
7) Rinse thoroughly with fresh water and a clean cloth
to wipe off the solution.
8) Refit the Ice Deflector and Thumbscrews. Close
the Bin Door.
Note: Some solutions may cause damage to the
Bin liner surfaces or corrosion on the metal
parts. Always rinse the sanitiser unless
directed otherwise by Hoshizaki guidelines.
[4] Storage Bin Door
Clean the Storage Bin Door at least once a week,
using a neutral non-abrasive cleaner. Rinse thoroughly
after cleaning and sanitise as required.
3
ENGLISH