Smoke hollow DG850C Manual Del Usuario página 15

Assembly
Fig. 14A
14
Fig.14B
Attach Control Panel Assembly
A
5
x4
Hardware needed:
Insert ignition wire on the middle burner onto the pin on the
piezo igniter pre-assembled on the control panel assembly.
(Fig.14A) and (Fig.14B)
Insert side burner ignition wire to pin on piezo igniter pre-
assembled on control panel assembly as shown. (Fig. 14C)
Place the control panel assembly onto the 3 burner tube
valves sticking out the front of the gas cabinet. You MUST
make sure that tip of the (3) valves go completely INSIDE
each opening of the burner tubes (Fig. 14D).
Then attach the control panel assembly to the gas cabinet
using (4) M6x12 bolts from INSIDE of the cabinet as shown
25
(Fig. 14E) and (Fig. 14F)
Fig. 14C
Side Burner Ignition Wire
Fig.14D
Fig. 10C
Valve tip
Burner
Tube
Fig. 14E
Fig. 14F
A
A
A
A
15