Ambu aView 2 Advance Manual Del Usuario página 11

d) Remove the round screw covers on each side of the displaying unit
Insert the name plate removal tool in the hole by the screw cover. Press the name plate removal tool down to lift the
screw cover.
e) Remove the screws on all four edges of the displaying unit
Use the screwdriver to remove the screws. Total 10 screws must be removed: 4 screws on top, 4 on the bottom,
and 1 screw on each side.
f) Remove the back casing
Use the plectrum tool. Press it into the dividing line between the displaying unit and the back casing. On all four
edges, start in the middle and pull the plectrum tool towards the corners until the back casing is released. When the
two sides of the casing is disassembles, you will here a "click" sound, indicating that the locks are released. (Figure 7)
Figure 4 Removing the name plate
Figure 5 Removing the screw cover
Figure 6 Removing the screws
11