Safety, Care, Accuracy Test And Disposal; Safety And Protection - Microlife BP W100 Manual Del Usuario

Error Description Potential cause and remedy
«ERR 2» Error signal During the measurement, error signals
were detected by the cuff, caused for
instance by movement or muscle
tension. Repeat the measurement,
keeping your arm still.
«ERR 3» No pressure An adequate pressure cannot be gener-
in the cuff ated in the cuff. A leak may have
occurred. Check that the cuff is correctly
connected and is not too loose. Replace
the batteries if necessary. Repeat the
measurement.
«ERR 5» Abnormal The measuring signals are inaccurate
result and no result can therefore be displayed.
Read through the checklist for
performing reliable measurements and
then repeat the measurement.*
«HI» Pulse or cuff The pressure in the cuff is too high (over
pressure too 300 mmHg) OR the pulse is too high (over
high 200 beats per minute). Relax for 5
minutes and repeat the measurement.*
BP W100
All manuals and user guides at all-guides.com
* Please consult your doctor, if this or any other problem occurs
repeatedly.

9. Safety, Care, Accuracy Test and Disposal

• This instrument may be used only for the purpose described in this
• This instrument comprises sensitive components and must be
Error Description Potential cause and remedy
«LO» Pulse too The pulse is too low (less than 40 beats
low per minute). Repeat the measurement.*
If you think the results are unusual, please read through the
information in «Section 1.» carefully.

Safety and protection

booklet. The manufacturer cannot be held liable for damage
caused by incorrect application.
treated with caution. Observe the storage and operating condi-
tions described in the «Technical Specifications» section!
9 EN