Imetec Titanox K113 Instrucciones De Uso página 16

The reservoir may already contain some water as each product is tested before being placed
on the market.
Verify that the plug (12) is disconnected from the socket.
EN
Set the steam selector (5) to 0 [Fig. B].
Open the latch (6).
Set the iron in a position that facilitates filling the water and prevents it from overflowing.
Slowly pour the water into the reservoir (10) using the special cup (13) [Fig. C].
Do not exceed the maximum (MAX) level indicated on the reservoir (10).
Close the hatch (6).
SELECTING THE TEMPERATURE
Set the iron upright.
Insert the plug (12) in the socket.
Set the temperature according to the type of fabric in line with the international symbols
shown on the labels; using the adjustment knob (2) [Fig. D].
The plate temperature LED (1) indicates that the iron is warming up.
Wait for the plate temperature LED (1) to go off before starting to iron.
Consult the table below to select the correct temperature:
Label Type Temperature
garments material selector
•
synthetic fibres e.g. viscose, polyesther
• •
silk, wool
• • •
cotton, linen
It is recommended to place a cloth between the iron and the fabric when using the iron for
the first time.
It is recommended to direct a jet of steam onto the cloth while holding the iron slightly raised
before starting to iron, for any residual condensation to be let out.
IRONING WITHOUT STEAM (DRY)
Follow the instructions in the "steam ironing" section, leaving the steam selector (5) set to 0.
IRONING wITH STEAM
Select the amount of steam via the steam selector (5).
Move the steam selector (5) to any position between minimum and maximum according to
the desired amount.
Continuous steam will only be dispensed when the iron is in a horizontal position.
This stops when the iron is set upright or the steam selector (5) is set to 0.
Steam can only be used at the highest temperatures, as indicated by the symbol on the
temperature adjustment knob (2) [Fig. D].
If the selected temperature is too low, water droplets may drip from the plate.
The plate temperature LED (1) goes on intermittently while ironing, thereby indicating that
the selected temperature is maintained.
14