Roborock E5 Manual Del Usuario página 23

Instructions for Use
Spot Cleaning
In Standby or Pause mode, press and hold the
Spot Cleaning. The robot will clean a 1.2m (3.9ft) in diameter circle
spiraling out from its starting point. After cleaning, the robot will
return to the start point.
Note: Starting Spot Cleaning in Pause mode will stop the current cleaning cycle.
Errors
If a runtime error occurs, the Power Indicator will flash red quickly,
and a voice prompt will sound. Refer to "Troubleshooting" for
details.
Note:
• The robot will automatically enter Sleep mode after 10 minutes of inactivity in an Error
state.
• Docking the robot in an Error state will stop the current cleaning cycle.
Sleep
If inactive for more than 10 minutes, the robot will automatically
enter Sleep mode. The Power Indicator will flash every few
seconds. Press any button to wake the robot.
Scheduled Cleaning
Use the mobile app to set scheduled cleanups. The robot will
automatically clean at the specified times and return to the
Charging Dock after each clean.
Reset WiFi
button to start If a mobile phone cannot connect to the robot due to router
configuration changes, forgotten password, or any other reason,
reset the WiFi. Open the top cover to reveal the WiFi Indicator,
then press and hold the
WiFi" voice alert sounds. When the WiFi Indicator Light flashes
slowly, the robot has entered network configuration mode.
Note:
you need to reconnect, reset the WiFi, and try again.
Suction Power
Use the Xiaomi Home app to choose from Quiet, Balanced, Strong,
or MAX modes. The Balanced mode is the default.
Do Not Disturb (DND) Mode
When DND mode is activated, an active cleaning cycle will finish,
no voice alerts will sound, and the Power Indicator Light will dim.
DND mode is enabled by default from 22:00 to 08:00. You can
use the mobile app to disable Do Not Disturb mode or change its
effective time.
23
and
WiFi will be automatically disabled if the time taken to connect exceeds one hour. If
buttons until the "Resetting