Festool SYMMETRIC SYM 70 E Manual De Instrucciones Original/Lista De Piezas De Repuesto página 13

Compound mitre saw
SYMMETRIC SYM 70
Table of contents
1 Technical data
2 Graphical symbols
3 Intended use
4 Safety instructions
5 Machine elements
6 Settings
7 Power supply and start-up
8 Operation
9 Service and maintenance
10 Accessories
11 Disposal
12 Warranty
1 Technical data
Power
Rotational speed (idle)
Mitre angle
Inner angle
Outer angle
Cutting range
max. workpiece height
max. workpiece width
Saw blade
Weight
Protection class
The specifi ed illustrations are at the begin-
ning of the Operating Instructions.
2 Graphical symbols
Caution. Danger!
Read the operating instructions/notes
Wear ear protection!
3 Intended use
The electric power tool is a stationary unit
designed for sawing blocks of wood, plastic
or aluminium.
Other materials, in particular steel, con-
crete and mineral materials, must not be
processed.
Aluminium must only be sawed with the
special saw blades from Festool designed
for this purpose.
The electric power tool is designed and
1150 W
2700 - 5200 rpm
0° - 68°
0° - 60°
70 mm
80 mm
216 x 2.4 x 30 mm
9.6 kg
/ II
approved for use by trained persons or
specialists only.
The user bears the responsibility for
damage and accidents caused by
improper use.
Other risks
In spite of compliance with all rel-
evant design regulations, dangers
may still present themselves when
the machine is operated, e.g.:
• Workpiece parts being thrown off
• Parts of damaged tools being thrown off
• Noise emission
• Sawdust emission
4 Safety instructions
4.1 General safety instructions
Before using the machine, care-
fully read all of the attached safety
instructions and the Operating In-
structions.
• Keep all of the attached documents and
pass on the documentation if the machine
changes ownership.
• Never allow children to use the machine.
• Before using the machine, make yourself
suffi ciently familiar with the application,
setting and operation of the machine.
4.2 Machine-related safety
instructions
Safety precautions
• Always use original Festool tools (in ac-
cordance with EN 847-1).
• Use only correctly sharpened tools without
damage or deformation. The maximum
rotational speed specifi ed on the tool must
be observed.
• Select the saw blade suitable for the ma-
terial you wish to work on.
• Do not use saw blades made of high-speed
steel.
• Only use spacers and spindle rings speci-
fi ed by Festool.
• Ensure the work area has adequate light-
ing.
• Ensure that the machine is on a fi rm base.
Place the machine on a fl at fl oor or secure
the machine fi rmly on a bench or table.
13