Tabla de contenido
Publicidad
STACKING OPTION:
11
11
(If not stacking units, go to step 12)
IMPORTANT: Units that are stacked on top of another unit must be attached to each other as indicated in this step. These units must
be positioned against a wall and the upper unit must be attached to a wall.
You may need someone's help in this step.
Remove the SKIRTS from the upper unit.
Fasten the upper unit to the lower unit. Use two SILVER 1-1/8" FLAT HEAD SCREWS (X) through the holes in the underside of the
TOP (C) and into the BOTTOM (D).
NOTE: The holes in the TOP are not through holes. Use a little extra force while turning these SCREWS.
411967
X
SILVER 1-1/8" FLAT HEAD SCREW
(2 used in this step)
www.sauder.com/services
C
D
Page 15
Publicidad
Tabla de contenido
