All manuals and user guides at all-guides.com
ADJUSTMENT INSTRUCTIONS, Continued
Adjustment Instructions for Isolette and Nesting Pad
1. Turn the valve counter-clockwise to open. Slide the pump's rubber nozzle over the valve
and inflate until the product arches slightly upward. Turn the valve clockwise to close.
Remove the pump.
2. Place the infant on the mattress overlay. To properly immerse the infant, adjust the
Isolette or Nesting Pad by placing your open hand under the infant's lowest bony
prominences, and then release air until there is no more than 1 in. (2.5 cm) and no less
than 1/2 in. (1.5 cm) between the areas of high risk and the base of the Isolette or Nesting
Pad.
3. Turn the valve clockwise to close.
Adjustment Instructions for Thyroid Pillow
1. Turn the valve counter-clockwise to open. Slide the pump's rubber nozzle over the valve
and inflate the pillow to the level needed for hyperextension of the neck.
2. Turn the valve clockwise to close and remove the pump.
Adjustment Instructions for Head / Neck Pillow
1. Turn valve counter-clockwise to open. Slide the pump's rubber nozzle over the inner
valve and inflate the pillow until it begins to slightly arch upward.
2. Turn valve clockwise to close and remove pump.
3. Repeat for the outside valve.
4. Place the individual's head / neck on the pillow. To properly immerse the individual's
head / neck, adjust the pillow by placing your open hand under the individual's head /
neck, and then release air until there is no more than 1 in. (2.5 cm) and no less than 1/2
in. (1.5 cm) between areas of high risk and the base of the Head / Neck Pillow.
5. Turn each valve clockwise to close.
CLEANING & DISINFECTING
Cleaning and disinfecting are two separate processes. Cleaning must precede disinfection.
NOTE: Before use by a different individual, clean, disinfect, and check product for proper
functioning.
To clean the Reusable Overlay Cover and Overlay Enclosure Cover:
Remove cover from mattress overlay. Machine wash, gentle cycle, in cold
water (30˚C) with a mild detergent. May also wipe clean with neutral
detergent and water. Rinse thoroughly. Tumble dry low.
NOTE: DO NOT dry clean the Reusable Overlay Cover.
To disinfect the Reusable Overlay Cover and Overlay Enclosure Cover:
Hand wash, using a dilution of one part household bleach to nine parts water.
Quaternary-type disinfectants may also be used in concentrations recommended
by the manufacturer. Rinse thoroughly. NOTE: The cover may be machine washed
occasionally in hot water (60˚C) for disinfection. However, ROHO, Inc.
recommends against repeated washings at high temperatures, as this
can accelerate degradation of the cover. Tumble dry low.
NOTE: Follow guidelines on bleach or disinfectant container.
12