H Troubleshooting; General Troubleshooting - Nordcap Zanussi 406402279 Instrucciones De Instalación

H TROUBLESHOOTING
H.1

General troubleshooting

Anomaly
The dishwasher does not
start
The dishwasher does not
wash well.
Glasses and dishes are not
dried properly.
Condensation on glasses.
Stains on the glasses.
Excessive foam in the tank.
Type of Possible causes
anomaly
Blocking The dishwasher is not connected
to the main power supply.
The door is opened.
The tap is close.
The water inlet filter is clogged.
Too low pressure in hydraulic
circuit.
Overflow not inserted (only for
appliances without drain pump).
Loss of No scrape action before putting
performance. dishes in the racks
The wash arms are clogged by
solid food remains. Residual food
has not been removed from
dishes.
The wash arms are not properly
installed.
The dishes are not correctly
placed in the racks.
The dosing of detergent is not
correct.
The detergent tank is empty.
Detergent pump does not work.
The wash tank suction filter is dirty. Clean wash tank suction filter
Loss of The container of rinse aid is empty. Check that there is rinse-aid in the
performance.
Rinse aid pump does not work.
The water temperature of the rinse
module is low.
Foamy detergent present in the
wash tank.
Loss The container of rinse aid is empty. Check that there is rinse-aid in the
performance.
Rinse aid pump does not work.
Loss of Foamy detergent present in the
performance. wash tank.
The dosing of rinse aid is not
correct.
The hardness of the water is too
high or too low.
Loss Residuals of food or detergent,
performance. used for manual prewash, remains
in the dishes.
Wash water temperature is too low. Call detergent and rinse aid service
Foamy detergent present in the
wash tank.
Actions
Check if the appliance main circuit
breaker is in ON position.
Close the door
Open the tap.
Clean the water inlet filter.
Check the minimum mains pressure.
Insert properly the overflow.
Scrape dishes before putting them in
the racks.
Check if the wash jets are clogged by
solid food remains.
Check the integrity of the wash arms.
Remove and fit again the wash arms.
Check if the dishes are correctly
placed in the racks.
Call detergent and rinse aid service
centre.
Check that there is detergent in the
container and if necessary top it up.
Call detergent and rinse aid service
centre.
thoroughly.
container and if necessary top it up.
Call detergent and rinse aid service
centre.
Call the service centre
Check if the dishes were not
immersed in foamy detergent (e.g.
hand wash detergent) before being
put in the dishwasher.
Only use "non-foaming" products for
professional dishwashers.
container and if necessary top up.
Call detergent and rinse aid service
centre.
Only use "non-foaming" products for
professional dishwashers.
Call detergent and rinse aid service
centre.
Adjust the amount of detergent and
rinse aid.
Call detergent and rinse aid service
centre.
Remove residuals of food or detergent
from the dishes.
centre to set the temperature in
according to the detergent
specifications.
Empty and refill the tank with water
until the foam has been removed.
ENGLISH
19