Changing The Batteries - Dräger UCF 6000 Instrucciones De Uso

The LEDs on the charger provide the following information:
Signal Meaning
The battery is charging.
The battery is fully charged.
Error during the charging process.
To ensure that a fully charged battery is available at all times, Dräger
recommends always placing the rechargeable battery into the charger
when it is not in use. Loss of capacity due to a memory effect will not
occur. If the rechargeable battery/thermal imaging camera is left in the
charger, the charger will recharge the battery from time to time to ensure
that it is always fully charged when needed. This will not damage the
battery.
4.2.3

Changing the batteries

WARNING
!
Do not change batteries in areas subject to explosion haz-
ards. Otherwise, an explosion may occur.
NOTICE
i i
Only use the Dräger battery LBT 001* for the Dräger
UCF 7000. Other batteries are not allowed for this thermal
imaging camera.
Dräger UCF 6000/7000
1. Loosen the screws under the
handgrip with the supplied Al-
len key.
2. Insert the Allen key through the
opening in the handgrip to push
the old battery out of the
handgrip.
3. Remove the old battery.
4. Make sure the seal at the new
battery is clean. Wipe the con-
tact surface with a lint-free
cloth.
5. Insert the new battery into the
handgrip of the thermal imag-
ing camera.
6. Tighten the screws.
4.2.4 Attaching the crawling plate to the camera
(optional)
The thermal imaging camera always includes the crawling plate. It can
be used with or without crawling plate. Mount the crawling plate to the
handgrip as follows:
Insert the camera handgrip into the crawling plate, and screw it
into the tripod mount.
NOTICE
i
i
If the camera with crawling plate is to be mounted to a tripod,
screw the tripod to the crawling plate.
Use
00721803.eps
33