Use; Notes On The Safe Use Of Rechargeable Batteries; Preparation For Use; Charging The Rechargeable Batteries - Dräger UCF 6000 Instrucciones De Uso

Ocultar thumbs Ver también para UCF 6000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61

Use

4
Use
4.1

Notes on the safe use of rechargeable batteries

WARNING
!
Improper use of rechargeable batteries can cause fires, ex-
plosions and other hazards.
Do not disassemble, open, manipulate or convert the recharge-
able battery.
Do not insert foreign objects into the rechargeable battery.
Do not drop, squeeze, bend, deform, puncture or shred the re-
chargeable battery.
Do not expose the rechargeable battery to excessive heat or put it
in a microwave oven.
4.2

Preparation for use

4.2.1
Preparing the charger
Insert the plug of the power
pack into the bottom of the
charger to connect the power
pack and the charger.
To release the power cable
from the charger, press the
holder (1) and pull the plug
from the charger.
32
4.2.2
Prior to first use, each new rechargeable battery must be charged fully.
A new, fully charged battery allows 4 hours of operation under normal
conditions. The operating time depends on several factors, (e. g. am-
bient temperature, brightness of image, image content) and may vary
accordingly.
Dräger recommends to insert a fully charged battery into the thermal
imaging camera before use.
Charge the battery as follows:
1. Insert the power pack into the bottom of the charger.
1
2. Connect the charger to the mains using the power pack.
3. Place the thermal imaging camera and/or a rechargeable battery
00621803.eps

Charging the rechargeable batteries

WARNING
!
The charger must not come into contact with water. Other-
wise short-circuiting can occur.
Do not charge camera and batteries in areas subject to explo-
sion hazards. Otherwise, an explosion may occur.
CAUTION
!
Charge the battery at an ambient temperature of 10 °C to
35 °C (50 °F to 95 °F). The charger stops charging and indi-
cates an error to prevent damage to the charger when tem-
peratures exceed this range. The charger continues charging
as soon as temperatures reach the permissible range again.
into the charger.
The typical charging time is 3 hours.
Dräger UCF 6000/7000

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ucf 7000

Tabla de contenido