Audio Adjustments; Introduction Of Audio Adjustments - Pioneer DVH-P5000MP Manual De Instrucciones

Section
12

Audio Adjustments

Introduction of audio
adjustments
23
1 4
1 Preset equalizer indicator
Shows which equalizer preset is currently
selected.
2 SFEQ indicator
Appears in the display when SFEQ function
can be activated.
3 EQ-EX indicator
Appears in the display when EQ-EX function
can be activated.
4 CUSTOM indicator
Shows when custom equalizer curve is pre-
sently selected.
5 Loudness indicator
Appears in the display when loudness is
turned on.
6 SW indicator
Shows when the subwoofer output is turned
on.
7 Audio display
Shows the audio adjustments status.
Important
If the multi-channel processor (DEQ-P7000) is
connected to this unit, the audio function will be
changed into the multi-channel processors
56
En
All manuals and user guides at all-guides.com
5 6
7
audio menu. For details, refer to Introduction of
DSP adjustments on page 63.
% Press A to display the audio function
names.
Press A repeatedly to switch between the fol-
lowing audio functions:
FAD (balance adjustment)EQ (equalizer
curve adjustment)B (bass and treble level
adjustment)LOUD (loudness)SUB, W
(subwoofer on/off setting)/NOFAD (non fading
output on/off setting)80: 0 (subwoofer set-
ting)/NOFAD (non fading output setting)
HPF (high pass filter)SLA (source level ad-
justment)
# If EQ-EX function has been selected and only
when EQ-EX is turned on and CUSTOM is se-
lected as the equalizer curve, you can switch to
B.
# When the subwoofer controller setting is only
P/O :FUL, you cannot switch to SUB, W. (Refer to
page 78.)
# You can select the 80: 0 only when subwoofer
output is turned on in the SUB, W.
# When the subwoofer controller setting is only
P/O :FUL, you can switch to the non fading out-
put on/off setting. (Refer to page 78.)
# You can select the non fading output setting
only when non fading output is turned on in the
non fading output on/off setting.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.