Using The Equalizer; Recalling Equalizer Curves; Adjusting Equalizer Curves - Pioneer DVH-P5000MP Manual De Instrucciones

Section
12 Audio Adjustments
# FAD : 0 is the proper setting when only two
speakers are used.
# When the rear output setting is R-SP :S/W,
you cannot adjust front/rear speaker balance.
Refer to Setting the rear output and subwoofer
controller on page 78.
3 Press m or n to adjust left/right
speaker balance.
When you press m or n, BAL : 0 is dis-
played. Each press of m or n moves the
left/right speaker balance towards the left or
the right.
BAL : L9  BAL : R9 is displayed as the left/
right speaker balance moves from left to
right.

Using the equalizer

The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.

Recalling equalizer curves

There are six stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
SPR-BASS Super bass
POWERFUL Powerful
NATURAL Natural
VOCAL Vocal
CUSTOM Custom
EQ FLAT Flat
! CUSTOM is an adjusted equalizer curve
that you create.
! A separate CUSTOM curve can be created
for each source. If you make adjustments,
58
En
All manuals and user guides at all-guides.com
the equalizer curve settings will be memor-
ized in CUSTOM.
! When EQ FLAT is selected no supplement
or correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
EQ FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
SPR-BASSPOWERFULNATURAL
VOCALCUSTOMEQ FLAT

Adjusting equalizer curves

You can adjust the currently selected equalizer
curve setting as desired. Adjusted equalizer
curve settings are memorized in CUSTOM.
1 Press A to select EQ.
Press A until EQ appears in the display.
2 Press m or n to select the equalizer
band to adjust.
Each press of m or n selects equalizer
bands in the following order:
EQ-L (low)EQ-M (mid)EQ-H (high)
3 Press r or q to adjust the level of
the equalizer band.
Each press of r or q increases or de-
creases the level of the equalization band.
+6  6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Note
If you make adjustments, CUSTOM curve is up-
dated.