Husqvarna R 316TX Manual De Usuario página 20

2. ENGINE
Replace the engine oil. Refer to
page 28 .
Replace the engine oil filter. Refer to
on page 28 .
Replace the spark plug. Refer to
23 .
Do a check on the lights (if applicable).
Update the firmware (if applicable).
Do a check of the battery and charge if it is necessary.
3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM
Do an inspection of and adjust the front and rear wheel rotation speed (only
AWD).
Replace the transmission filter (only AWD).
Replace the spin on filter for the servo (if applicable).
Do a check of the cooling fan on the hydrostatic transmission.
Do a check of the oil in the transmission and fill if it is necessary. Refer to
a check of the transmission oil level on page 29 .
Examine and adjust the parking brake.
Replace the oil in the transmission. Refer to
oil level on page 29 .
4. CUTTING EQUIPMENT
Clean the outer and inner surfaces of the cutting deck and the cutting deck cov-
ers.
Do a check of and adjust the cutting height and pitch setting.
Examine the blades in the cutting deck, sharp and balance if needed.
20
To replace the engine oil and the oil filter on
To replace the engine oil and the oil filter
To examine and replace a spark plug on page
To do a check of the transmission
First Maintenance interval
servicing in hours
50
hours or
O one (TN)
time each
O
O
O
O
First Maintenance interval
servicing in hours
50
O
O
O
O
To do
O
O
First Maintenance interval
servicing in hours
50
O
O
844 - 009 - 25.11.2021
100 200
100
year
O
O
O
O
O
100 200
O
O
O
O
O
O
O
100 200
O
O
O