Display - Troubleshooting - Husqvarna R 316TX Manual De Usuario

Problem
The engine apparently has no
power
The transmission does not have
sufficient power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry

Display - Troubleshooting

Symbol
844 - 009 - 25.11.2021
Cause
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission cold air intake or the cooling fins are blocked.
The fan on the transmission is damaged.
There is no oil in the transmission or the oil level is too low. See
of the transmission oil level on page 29 .
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
tery safety on page 12 .
The blades are loose. See
One or more of the blades are unbalanced. See
27 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
21 .
The tire pressure is different on the right and left sides. See
page 25 .
The product is operated at a too high speed. See
page 18 .
The engine speed is too low. See
The drive belt slips.
Name
Slope indicator
Oil pressure sensor
To clean and change the air filter on page 23 .
Battery safety on page 12 .
To examine the blades on page 27 .
To examine the blades on page 27 .
To get a good cutting result on page 18 .
To get a good cutting result on page 18 .
Indication on the dis-
play
The symbol shows.
The symbol flashes.
The symbol shows.
To examine the blades on page
To clean the product on page
To get a good cutting result on
Sound Cause
You operate the product in a
slope >10°. Refer to
-
structions for operation on page
9 .
You operate the product in a
slope >15°. Refer to
-
structions for operation on page
9 .
Low oil pressure. Refer to
1 long
a check of the engine oil level on
sound.
page 28 .
To do a check
Bat-
Tire pressure on
Safety in-
Safety in-
To do
31