INTENDED USE
This product is intended for domestic lawn
mowing.
ASSEMBLy
ImPORTANT! Before you assemble
the lawn mower, check the accessories
according above information, make sure the
accessories are completed.
1. FITTING ThE hANDLE (See A1, A2,
A3, A4)
1) Remove the screws (X 2) on the both side
of deck. (Fig A1)
2) Insert the lower handle (9) into the holes
provided.
3) Secure with the screws provided.(Fig A2)
4) Attach the upper handle (8) with the bolts
and lock cam lever (3) to the lower handle
(9).(Fig A3)
5) Tightening the two Lock cam levers. Check
that the handle is FULLY secured.
The cam lever pressure can be adjusted by
adjusting the lock cam lever (3) clockwise/
counter-clockwise. DO NOT OVER TIGHTEN.
NOTE: Ensure the bolts are fully inserted
through the handles before fitting the handle
knobs.
6) Attach the cable clips (2) provided, to the
upper and lower handle. Insert the cable
into the clips ensuring there is enough
cable slack. (Fig A4)
2. GRASS COLLECTION bAG ASSEmbLy
Connect the grass box handle to the box top
as shown in Fig B1-B4.
Step 1.
Press the front of the handle briefly.
(Fig B2)
Step 2. Then push it forward. (Fig B2)
Step 3. Push down the back of the handle.
(Fig B2)
Step 4. Clip the plastic clips over the metal
frame. (Fig B3)
WARNING: Don't fit the handle in
reversed direction. Fit the handle as
shown in Fig b1.
Electric lawn mower
All manuals and user guides at all-guides.com
3. GRASS COLLECTION bAG FITTING
(See C1, C2, C3)
1) Turn the mower off, wait until blade stops.
2) Raise the safety flap (10) and hold it up.
3) Pick up the grass bag by the handle, and
4) Release the safety guard to lock the grass
NOTE: Depress the grass bag slightly to
ensure that it is completely installed.
4. REmOVING/EmPTyING
Hold the grass bag, lift the safety flap (10) and
hold up. Remove grass bag (5).
before using. Never lift the safety flap (10)
when the lawn mower is being used without
fitted grass bag.
OPERATION
1. STARTING AND STOPPING (See Fig
D1, D2)
STARTING
Connect the plug to the mains and switch ON.
The switch box is provided with a lock-
off button to prevent accidental starting.
With one hand press and hold the safety
button (D1), with the other hand squeeze the
switch lever (D2) towards the handle, and
release the safety lock-off button. The machine
is now started, wait until the product is at full
speed before cutting the grass. Then use both
your hands to hold the switch lever on both
sides to keep it running.
STOPPING
Release the switch lever.
2. hOW TO mOW
For cutting convenience, it may be best to start
mowing at a point close to the power supply
and to work your way away from the supply.
Mow the lawn at a right angle from the power
supply and place the power cable to side
which has already been cut.
NOTE: The motor is protected by a safety
cut out which is activated when the
position grass bag on the lower hooks (a)
on the mower deck (Fig. C2).
bag into position. Ensure the grass bag is
installed securely (Fig. C3).
WARNING! Always check the safety flap
can close the discharge outlet tightly
11
11
EN