Environmental Protection - Worx WG706E Traducción De Las Instrucciones Originales

gloves (not provided) and a spanner wrench
(not provided) to remove the blade. Hold
the blade (14) and unscrew the blade bolt
(13) anticlockwise using a spanner wrench.
Remove blade and attach a new one to the
blade bolt.
Ensure that the blade is properly positioned as
seen in Fig.I1, then firmly tighten the bolt. Do
not over tighten.
Renew your metal blade after 50hrs mowing
or 2 years, which ever is the sooner-regardless
of condition.
If the blade is cracked or damaged
replace it with a new one.
STORAGE: (See fig J)
Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and
debris, especially from the ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage loosen the handle knobs and
fold the handles.
You could carry the mower by carry handle
(11).
Ensure cables are not stuck or entangled when
folding or unfolding upper handles. Do not
drop the handles.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
Electric lawn mower
All manuals and user guides at all-guides.com
PLUG REPLACEMENT
(UK & IRELAND ONLy)
If you need to replace the fitted plug then
follow the instructions below.
ImPORTANT
The wires in the mains lead are colored in
accordance with the following code:
blue = Neutral
brown = Live
As the colors of the wires in the electrical cord
of this appliance may not correspond with the
colored markings identifying the terminals
in your plug, proceed as follows. The wire
which is colored blue must be connected to
the terminal which is marked with N. The wire
which is colored brown must be connected to
the terminal which is marked with L.
plug. Only fit an approved 13ABS1363/A plug
and the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
WARNING! Never connect live or
neutral wires to the earth terminal of the
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
13 13
EN