Internal Memory - Ecolab EcoAdd Instrucciones De Servicio

Internal memory

After 95% of the storage capacity is filled, the colour of the corresponding segment
changes to red (item 3).
By this point at the latest, the corresponding memory should be exported via USB stick
and then reset (deleted), so that no entries are lost.
If the data is not saved in time, the oldest entries are always overwritten. The display
sequence is determined as follows (from left to right): Log data memory (item 1), operating
data memory (item 2), alarm data memory (item 3).
The pump is equipped with an internal
memory, which stores the log data, operating
data and alarm data.
1 2 3
All this data can be downloaded and saved to
a suitable USB stick using the export function
on the pump.
Since the memory on the pump is limited,
the memory status is graphically displayed at
the operational level just before reaching the
memory limit.
The memory status is visible only when one
of the three storage types is at least 75%
filled. In this case, at least one of the three
fields is orange (item 1).
61
Control/software
MAN046939 Rev. 6-10.2021