Ecolab EcoAdd Instrucciones De Servicio página 335

Importing and/updating the configuration
Prior to the data transfer, it must be ensured that the source and target pumps
have the same pump code.
The program displays only configuration files located on the USB stick at the
path: /ECOADD/IMPORT.
During the USB export (
access code is always stored in the export file. If one of the two pumps has an
active access code, a prompt is displayed prior to the transfer asking whether
the access code should also be transferred.
General import procedure
1.
Insert the USB stick in the PC and select the "ECOADD" folder.
2.
Create a new folder and name it "IMPORT".
3.
Move the file from the "EXPORT" folder to the "IMPORT" folder.
4.
Remove the USB stick.
5.
Select the main menu on the target pump.
6.
Insert the USB stick in the USB socket on the target pump.
7.
Call the "Configuration" menu item.
ð The display now shows "USB export" and "USB import".
8.
Choose "USB import" and select the required import file.
ð The import is carried out.
The following different cases exist for an import:
Ä 'Import file and pump do not have codes' on page 132
n
Ä 'Import file does not have codes; pump has codes' on page 133
n
Ä 'Import file has codes; pump does not have codes' on page 134
n
Ä 'Import file and pump have codes' on page 135
n
Ä 'Exporting a configuration' on page 130 ), the
131
Control/software
MAN046939 Rev. 6-10.2021